To Next Page
M
Melinda ScottNov 2, 2025
Why Makita PF 1010 motor will not work?
- AahallNov 2, 2025
If the Makita Water Pump motor isn't working, start by checking the mains voltage. If that's not the issue, the protection device may be defective and require replacement. Also, the motor protection might be disconnected due to the pump straining or being blocked; in that case, check and reconnect the motor protection after clearing any blockages. Ensure that the water level is sufficient and reconnect the dry operation protection if it has disconnected because the water level has fallen too much. Other potential causes include a defective pump (inspect and replace if necessary), a clogged suction opening (clean it), a blocked check valve or bent delivery pipe (unblock or straighten it), a clogged delivery pipe (clear it), foreign bodies in the pump or a blocked pump impeller (remove forei...
General
