Makita TD110D User Manual

11 ENGLISH
Cleaning without nozzle
You can pick up powder and dust without nozzle.
MAINTENANCE
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
After use
NOTICE: Putting the cleaner against the wall
without any other support cause the cleaner to
fall down and be damaged.
Cleaning
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
NOTICE: Do not blow dust sticking on the
cleaner and lters by air duster. It brings dust into
the housing and causes failure.
NOTICE: After washing lters, dry them thoroughly
before use.Insufcientlydriedltersmaycausepoor
suction and shorten the service life of the motor.
NOTICE: After cleaning lters and sponge lter,
be sure to re-install them before use. If you use the
cleanerwithoutltersandspongelter,dustcomes
into the motor housing and cause malfunction.
Cleaner body
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Cleanoutalsothesuctionopeningandltermounting
area.
Filter
Washthelterinsoapywaterwhenitiscloggedwith
dust and the cleaner power becomes weak. Dry it out
thoroughly before use.
Sponge lter
Whenthespongelterbecomesdirty,cleanitas
follows.
1. Removethelter.
2. Pulloutthespongelterfrombetweenthepillars.
3. Cleanthespongelterbytappingorwashing.If
you wash it, dry it out thoroughly before use.

Makita TD110D Specifications

General

Voltage	10.8V
Max Torque	110 Nm
No Load Speed	0-2, 600 RPM
Impacts Per Minute	0 - 3, 200 ipm
Battery Type	Li-ion
Driving Shank	1/4" Hex
Machine Screw	M4-M8
Standard Bolt	M5-M12
High Strength Bolt	M5-M10
Coarse thread screw (length)	22-90 mm
Weight with battery	1.2 kg
Length	153 mm
Blows Per Minute	0 - 3, 200 ipm