7
NOTE:
• When using the straight guide, be sure to install it
on the right side in the feed direction. This will help
to keep it flush with the side of the workpiece.
Straight guide
011950
The straight guide is effectively used for straight cuts
when chamfering or grooving.
1
2
3
011951
To i ns ta ll th e st ra igh t gui de , in se rt t he gu i de b ars in t o th e
holes in the tool base. Adjust the distance between the
bit and the straight guide. At the desired distance, tighten
the wing bolts to secure the straight guide in place.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
A
011952
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a straight
board to the workpiece and use it as a guide against the
router base. Feed the tool in the direction of the arrow.
Dust nozzle set (For European countries only)
1
2
011953
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
011954
Then connect a vacuum cleaner to the dust nozzle.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.
To main ta in pro du c t S AFE TY and RE LI AB ILI TY, r ep ai rs ,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
1. Dust nozzle
2. Thumb screw
1. Guide bar
2. Clamp screw
3. Straight guide
To Next Page
Loading...