MAKING A CUP OF COFFEE
The machine is only compatible with MALONGO 1,2,3 SPRESSO
®
pods.
1 - Fill the tank with fresh water ( ).
2 - Plug in the power cable ( ).
3 - The central light ( ) will display 3 colours (blue, white and red) one after the other,
and then go out. The machine is now on stand-by.
4 - Press coee button ( ) or ( ) to start heating (both coee buttons flash).
5 - When the machine reaches the required temperature, the two coee buttons ( )
and ( ) will stay ON steady, and the machine is ready to serve coee.
6 - Open the coee pod packaging, remove the lid, and take out the pod.
7 - Pull on the machine handle ( ) to maximum while lifting to reveal the pod slot.
8 - Insert the pod in the slot and check positioning (the pod must not protrude).
9 - Push the handle ( ) towards the control buttons until completely closed.
IMPORTANT: It is essential to fully close the handle in order to obtain a great cup of
coee. This Eco-Responsible machine is not equipped with an automatic closing device
to reduce energy consumption, therefore the user must push lightly on the bent end
of the handle with the palm of their hand, to fully close the handle.
It is easy to know when the required position has been reached, the handle will resist closing
when approaching closure and then all resistance will disappear when the handle is in the
correct closed position.
However, do not push hard on the very
end of the handle. Excessive pushing
forces can indeed be caused by a pod
remaining in the machine from a previous
cycle, or a full pod basket (empty the
pod basket on a regular basis to avoid
any damage to your new coee pods
for this reason).
6
13
2
3 4
3
4
1
1
19
NoticeEoh-4Trads-FRENESIT-MAJ092021.qxp_Mise en page 1 29/09/2021 16:52 Page 20
To Next Page
Loading...
Need help?
General
