Need help?Do you have a question about the Malouf Structures E455 and is the answer not in the manual?
Important pre-assembly and electrical safety instructions.
Safety guidelines for children, pets, and users with pacemakers.
Notes on intended use, weight limits, and hospital disclaimer.
Details on motor operation limits and electrical power ratings.
Regulatory compliance with FCC rules for RF transmission.
Familiarization with the adjustable base and its included parts.
Minimum two people required; open box flat on the floor, bottom facing up.
Place box in room, bottom up, and carefully remove packaging.
Remove base from box, set mattress side down, remove ties and check parts.
Hand tighten all legs into the bed frame until secure, noting placement options.
Connect the power cord jack to the receptacle on the bed motor securely.
With assistance, lift and turn the bed over to the mattress side up.
Insert one end of the retainer bar into its slot until it slides fully into place.
Plug the power cord into the wall outlet and prepare to run the test.
Learn remote functions and how to install batteries.
How to adjust and save Zero Gravity and Anti Snore positions.
Steps to pair the remote with the adjustable base if necessary.
Electronic components are pre-installed; learn input/output port locations.
USB ports are under the head portion for charging output only.
Install 9V batteries into the power supply for temporary power during outages.
Pair a single remote to operate two bases simultaneously via wireless connection.
Connect two bases using a sync cable to the control box of each.
Use the remote to test all functions for 3 seconds, returning to flat between presets.
Check wired connections, remote batteries, and remote syncing.
Check power cord, reset components by unplugging, and test outlets.
Details what the warranty covers and how coverage lasts over time.
Procedures for obtaining service and understanding state law implications.
To Next Page
General