EasyManua.ls Logo

MALTEC HDS7000W-PRO - Storage and Cleaning

MALTEC HDS7000W-PRO
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The green light will be on and off during usage, it will not influence any use when green
light off.
Red light show on it means short of water and it only showing for very quick time.
If you want to continue use, please turn off the power switch and wait cool for about 20
minutes before open the safety valve for water.
The right way to open the safety cap is Press down the dot first, at the same time unscrew
the safety valve by anti clockwise.
Please note that there is a risk of burns when pouring water since it is still hot.
Following steps from 1 ~3 for repeat using.
Storage & Cleaning
After use, please turn the power off.
If the water has not fully released, please open the safety valve until cooling and then pour
out the water.
If there is dirt on the surface of body, please use dry dishcloth with some water to wipe
gently.
Do not use water to spray the machine.
Don’t placen it under damp which may cause short circuit.
You can install the cord rewinder on the back of unit and assemble the power cord on it.
After cleaning please keep it in a dark and dry place.
17/31