Maintenance chart
35
A Clean water separator / pre-filter
A1 Change fuel filter, clean water separator, clean pre-filter
B Check injection nozzles, compression pressure, renewing if required
C D Change oil and oil filter, check that components are tight
D Check V-belts for damage, tighten up or change
D Tighten cylinder head bolts
E D Check and if necessary adjust valve clearance
D Check connection elements (bolts, clamps etc.) and tighten if necessary
F Renew axial face seal and bearing on water pump
I Clean air filter and change filter cartridge, reset maintenance indicator
(even earlier depending on accumulation of dust)
I1 Change air filter / filter cartridge
J Check concentration of coolant, correcting if necessary
K D Check oil level
D Check coolant level
D Check maintenance display on air filter
D Check water separator (if there is one)
D Check regarding pending EDC errors
D Visual check for exterior damage, stone impact, leakages
Every 4 years regardless of operating hours
D Renew coolant
D Replace radiator cap (filler valve, service valve)
The prescribed maintenance intervals presuppose the use of engine oil as per MAN
works norms M3277!
To Next Page
Loading...
