KEYLESS 042
KEYLESS 042
Programming and Installation Instructions
Programming and Installation Instructions
New Installation:
Program an Initial PIN
1. Enter the factory default PIN [ 0 0 0 0 ] on the Keypad
Then press the [ * ] button
2. Enter a new PIN (2 to 8 digits) of your choice [ ? ? ? ? ]
Then press the [ * ] button
3. Re-enter the new PIN [ ? ? ? ? ] to confirm
Then press the [ * ] button
► The new PIN is confirmed once the Keypad's backlit LED flashes 3 times and the unit emits a long beep.
Anti-Theft Feature
The Keypad is designed with a security feature to prevent thieves from continuously guessing the PIN. If
there are 10 consecutive incorrect PIN attempts made by the user, the Keypad will auto-lock itself for a
period of 10 minutes. Removing the battery will not disengage the anti-theft feature. Wait for a period of 10
minutes before resuming to program the Keypad.
► The Keypad is ready to receive an input as soon as the unit emits a beep when a button is pressed.
Timeout Feature
In the event that more than 15 seconds has elapsed between any two keypad inputs during the programing
procedure, the unit will emit an error code of 5 short successive beeps.
► The programming procedure in progress must be restarted.
Keypad Pairing / Programming Instructions:
SINGLE Door Mode Programming Instructions
Allows for 1 door to be operated by the Keypad.
Single Door Setting Pairing Testing
1. Enter the PIN [ ? ? ? ? ]
Then press the following sequence
of buttons [ * ] [ 0 ] [ # ]
1. Press and HOLD the LEARN
button on the On-Board Radio
Receiver for approx. 2 sec. or until
the White LED on the Receiver
flashes.
1. Enter the PIN [ ? ? ? ? ]
Then press the [ # ] button to
operate the door
2. Enter the PIN [ ? ? ? ? ]
Then press the [ # ] button
► The Keypad will emit 3 beeps as
confirmation.
► The Keypad will emit 3 beeps as
confirmation.
► The Keypad will emit 3 beeps as
confirmation and the door operator
will activate.
1-800-361-2260
www.manaras.com 2 TN1025 REV 4 - 2016/04/11
To Next Page
Loading...