Mangar Bathing cushion - Installation and Setup; Fitting the Bathing Cushion; Connecting Air Hose and Hand Control

bathing cushion
Fitting the Bathing Cushion in the bath
Pass the air hose through the loop in the corner •
of the backrest (A g.1), on the side that you
propose getting into and out of the bath. The
air inlet valve (B) can be rotated, allowing the
hose to be led to the appropriate corner.
Fold the backrest over onto the seat as indicated •
in g. 2. Lightly place the deated Bathing
Cushion in the middle of the empty bath with
the ‘handle’ (C) aligned with the centre of the
bath.
Hold the ‘handle’ and pull the Bathing Cushion •
towards the slope of the bath until there is a
gap of approximately 25mm (1”) between the
bath slope and ‘handle’ (C gs. 2 & 3).
Press all four suction cups down and check •
that they are securely stuck to the bath. Wet
them to help them stick if necessary.
Fold the backrest out so that it rests on • the
slope of the bath.
Connecting the air hose and hand control
Battery powered Airo:
Connect the air hose from the Bathing Cushion •
to the Airo air outlet socket (D g. 4).
Connect the Push Button Hand Control (• E) to
the socket (F).
Mains powered Airo:
Connect the air hose from the Bathing Cushion •
to the Lever Hand Control (G) and connect the
Lever Hand Control air hose to the Airo air
outlet or the wall mounted air outlet socket if
using with a Mangar International plumbed-in
air system.
If preferred, a Push Button Hand Control •
extension lead and an air hose extension are
available for connecting to the mains powered
Airo outside the bathroom.
3
freedom through lightweight solutions
MI0225 issue 3
1
A
B
3
25mm approx.
C
D
F
4
E
G
2
C