Mangar Bathing cushion - Operating the Bathing Cushion; Dry Trials; Getting Into the Bath

To Next Page

To Previous Page

bathing cushion

Dry trials (without water in the bath)

Select ‘Up’ on the hand control and when •

the relief valve blows (it will hiss), release the

‘Up’ button. Press rmly down on the Bathing

Cushion to secure the suction cups to the

surface of the bath. Check all four suction cups

are securely stuck to the bath. Wet them to help

them stick if necessary.

Whilst still clothed and with an assistant, carry •

out some dry ‘practice runs’ according to these

instructions (see below) until you are condent

to use the product.

Using the Bathing Cushion

WARNING: Please note that the Airo compressor

incorporates an important safety feature which will

ensure that the Bathing Cushion cannot be lowered

unless there is sufcient battery power to raise it

again. To action this feature effectively ALWAYS

INFLATE THE BATHING CUSHION USING THE

HAND CONTROL AND USE THE BATHING

CUSHION to lower yourself into the bath.

to get into the bath

Fill the bath with water at a suitable temperature •

(with the Bathing Cushion in the bath) .

With the Bathing Cushion • fully inated, sit on

the seat and then swing your legs into the bath

(g. 5). Ensure that you are seated centrally

and right at the back of the seat section.

Select ‘Down’ to lower yourself into the bath. •

Hold onto the side of the bath or to a grab

handle to steady yourself as you go down.

Note: you may nd it more comfortable to leave

a small amount of air in the Bathing Cushion,

to cushion yourself on the bottom of the bath

(g. 6).

MI0225 issue 3