Manhattan 177795 - Getting Started; Connect USB Receiver; Install Battery; Using Your Wireless Mouse

2
ENGLISH
Performance Wireless Optical Mouse • User Manual English
Thank you for purchasing the MANHATTAN
®
Performance Wireless Optical Mouse,
Model 177795. For specications, go to www.manhattan-products.com.
Installation
1. On the underside of the mouse, pull out the micro receiver and plug it into a USB
port on the computer.
2. Slide the cover o the battery compartment and insert the included AA battery;
then replace the cover. The scroll wheel LED should ash red for a few seconds to
indicate the mouse is ready to use.
Operation
• Operate the mouse within 10 m (33 ft.) of the receiver.
• Press the resolution button to cycle through the 3 resolution settings: 1000 dpi
(scroll wheel LED blinks once); 1500 dpi (LED blinks twice); 2000 dpi (LED blinks
three times).
• The scroll wheel LED lights red to indicate low battery power. NOTE: Use only
alkaline batteries.
• The mouse automatically enters a sleep mode after approximately 8 minutes of
inactivity to save power. Press any key or scroll to wake it.
• During extended periods of non-use, remove the battery to avoid corrosion and
store the receiver in its storage slot.
• If the signal carrying the identication code between the mouse and the receiver
is disrupted (possibly by a sudden rise in temperature, magnetic eld or vibration),
simply remove and reconnect the receiver, then press the right and scroll buttons
for a few seconds to re-establish the connection.
Scroll
wheel
& LED
Resolution
button
Battery
compartment
USB micro
receiver &
storage slot