Why is my Manhattan T1 remote control not working?
There are a couple of reasons why your Manhattan Measuring Instruments remote control might not be working: * The receiver (T2•R) might not be turned on, or something might be blocking its front. Make sure the front of the receiver is not obstructed. * The batteries in the remote control could be weak. Try replacing them with fresh batteries.
What to do if I don't hear audio on HD channels with Manhattan Measuring Instruments?
If you are not hearing any audio on HD channels with your Manhattan Measuring Instruments, it might be because the HD channels are broadcast with Dolby Surround audio, which your TV may not support. To fix this, go to the Picture & Sound section in the Settings menu and change the ‘HDMI Audio’ setting to ‘Stereo PCM’.
How to stop my Manhattan T1 Measuring Instruments T2•R from switching off after 3 hours?
Your Manhattan Measuring Instruments T2•R is set by default to go to standby after 3 hours without any interaction. To prevent this, go to the System section of the Settings menu and set Auto Standby to Off.
Why is the volume low after programming my Manhattan T1 remote?
The volume might be low because you didn't set the T2-R’s volume to maximum before programming your Manhattan remote to control your TV. To resolve this: 1. Reset your Manhattan remote by holding the SUB and buttons for 3 seconds until the LED blinks. 2. Turn the volume up to maximum on your T2-R. 3. Reprogram your Manhattan remote to control your TV.
Why doesn't Loop Out work in Standby on my Manhattan T1?
If Loop Out isn't working in Standby on your Manhattan Measuring Instruments, it's likely that the “Loop Out in Standby” setting is not turned on. To enable it, press MENU, then select ‘Settings’ -> ‘System’ -> ‘Loop Out in Standby.’
What to do if volume/mute buttons don't work on Manhattan T1 Measuring Instruments remote?
If the volume or mute buttons on your T2-R remote aren't working, it's possible they've been programmed to control the volume of another device. Reset your T2-R remote by following the instructions in ‘Reset Your Remote’.
How to reset my PIN for Manhattan T1 Measuring Instruments if I forgot it?
Your PIN can be reset with the master PIN. Please contact us.
General| Brand | Manhattan |
|---|---|
| Model | T1 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
