Manhattan T2-R - User Manual

Other manuals for Manhattan T2-R

Faq5 pages

Questions and Answers

A
amandaboyerJul 27, 2025
Why is my Manhattan Measuring Instruments remote control not working?
- C
  cindyjonesJul 27, 2025
  There are a couple of reasons why your Manhattan Measuring Instruments remote control might not be working: * The receiver (T2•R) might not be turned on, or something might be blocking its front. Make sure the front of the receiver is not obstructed. * The batteries in the remote control could be weak. Try replacing them with fresh batteries.
G
gallowaytimothyJul 31, 2025
What to do if I don't hear audio on HD channels with Manhattan T2-R?
- V
  Veronica WilsonAug 1, 2025
  If you are not hearing any audio on HD channels with your Manhattan Measuring Instruments, it might be because the HD channels are broadcast with Dolby Surround audio, which your TV may not support. To fix this, go to the Picture & Sound section in the Settings menu and change the ‘HDMI Audio’ setting to ‘Stereo PCM’.
B
Bonnie WalshAug 4, 2025
How to stop my Manhattan Measuring Instruments T2•R from switching off after 3 hours?
- S
  Shelby MeyerAug 4, 2025
  Your Manhattan Measuring Instruments T2•R is set by default to go to standby after 3 hours without any interaction. To prevent this, go to the System section of the Settings menu and set Auto Standby to Off.
T
tammy64Aug 8, 2025
Why is the volume low after programming my Manhattan T2-R Measuring Instruments remote?
- M
  Matthew VillegasAug 8, 2025
  The volume might be low because you didn't set the T2-R’s volume to maximum before programming your Manhattan remote to control your TV. To resolve this: 1. Reset your Manhattan remote by holding the SUB and buttons for 3 seconds until the LED blinks. 2. Turn the volume up to maximum on your T2-R. 3. Reprogram your Manhattan remote to control your TV.
M
Mrs. Maria Perry DVMAug 13, 2025
Why doesn't Loop Out work in Standby on my Manhattan T2-R?
- J
  Jeffrey Ramirez DVMAug 13, 2025
  If Loop Out isn't working in Standby on your Manhattan Measuring Instruments, it's likely that the “Loop Out in Standby” setting is not turned on. To enable it, press MENU, then select ‘Settings’ -> ‘System’ -> ‘Loop Out in Standby.’
E
Elizabeth MunozAug 17, 2025
What to do if volume/mute buttons don't work on Manhattan Measuring Instruments remote?
- O
  obautistaAug 18, 2025
  If the volume or mute buttons on your T2-R remote aren't working, it's possible they've been programmed to control the volume of another device. Reset your T2-R remote by following the instructions in ‘Reset Your Remote’.
A
Andre DavisAug 22, 2025
How to reset my PIN for Manhattan T2-R if I forgot it?
- E
  Eric HernandezAug 22, 2025
  Your PIN can be reset with the master PIN. Please contact us.