13
Your Manhattan remote can control the following functions on your TV:
• Standby
• AV (input selection). On most TV remotes this is labelled ‘AV’, ‘SOURCE’, ‘INPUT’ or .
• Volume Up/Down
• Mute
IMPORTANT
• Please set the volume on your T2•R to maximum before you continue.
• Some TV’s use non-standard remote signals and may not be supported.
Program your Manhattan Remote
1. Press the bottom left (SUB) and right (AD) buttons for 3 seconds.
» The Standby button lights up blue.
2. Press the button on the Manhattan remote you want to program: Volume Up/Down,
Mute, AV or TV .
» The blue Standby button starts blinking.
3. Point your TV remote at the Manhattan remote from a distance of 5cm then press and
hold your chosen TV remote’s button.
» If the button is programmed, the Standby button on the Manhattan remote turns o
and then goes solid again after about a second.
» If the button fails to be programmed, the Standby button will flash on and o 4 times
to indicate a learning error and you will be returned to Step 2.
4. Repeat steps 2 and 3 for all the buttons to program.
5. Press OK on your Manhattan remote to leave programming mode.
Reset Your Remote
To clear all programmed buttons and return them to their original state, hold the SUB and
buttons for 3 seconds until the LED blinks.
CONTROL YOUR TV
Manhattan Remote Your TV Remote
5 cm
To Next Page
Loading...
Need help?
General
