Manitou 220 TJ+ - Safety and Operation Guidelines; Platform Working Area and Stability; Rotation Block and Electrical Safety; Slope, Overload, and Emergency Procedures

t
IMPORTANT
t
We draw the operators' attention to the risks associated with using the aerial work platform, in particular:
- risk of loss of control.
- risk of loss of lateral stability of the aerial work platform.
- it is MANDATORY to wear a safety helmet and a safety harness when using the platform.
DAILY MAINTENANCE
PLATFORM WORKING AREA
• Before using the platform, check
the condition of the ground and
the bearing surfaces.
• If the wind speed is in excess of
45km/h, do not use the platform.
• Do not forget to mark out the
working area of the platform.
TURN TABLE ROTATION BLOCK
• This pin must be used to stop
the turn table rotating when the
platform is being transported by
truck or other means of transport
(train, etc.).
t
IMPORTANT
t
Do not forget to remove the turn
table rotation blocking pin when
using the platform.
ELECTRICAL HAZARD
t
IMPORTANT
t
Never stand or work in the
vicinity of any electrical sources.
4°
SLOPE AND OVERLOAD
Max. permissible slope: 4°
• When the maximum
permissible slope is
reached, a buzzer will sound
intermittently.
Overload:
• If the basket is overloaded,
a buzzer will sound
continuously.
EMERGENCY PROCEDURE
• If the operator should fall ill or find himself incapable of
manoeuvring, the person on the ground can take over the
basket controls by following the instructions:
- Toggle and hold switch 5 in position A. Releasing it prevents
movements from being activated (dead man switch).
- Lower the basket using the ground controls.
t
IMPORTANT
t
Pay attention to any constructions or objects
that may be under the basket.
BACKUP PUMP
• Button B make it possible
to carry out all basket
movements in order to
return it to the ground in
the event of a breakdown.
t
IMPORTANT
t
Only use in case of engine
failure or failure of the
electrical system.
5
A
STEERING MODE SELECTION
JIB ZERO POSITION
• Front and rear steering wheels in
opposite direction (tight turning).
• When button 21B is pressed and
held, the jib returns to its zero
position with automatic stop.
• LED 21A goes out once the jib has
reached its zero position.
• Front steering wheels.
• Front and rear steering wheels
in same direction (crab steering).
LOAD CHART
2
4
6
8
10
12
14
16
18
20
22
0 2 4 6 8 10 12 14 16 18
0 2 4 6 8 10 12 14 16 18
350 kg
771 lbs
=
=
+
+
110 kg
242 lbs
3
t
IMPORTANT
t
Never change the steering mode whilst driving.
B
21A
21B
27
GENERAL INSPECTION
CHECK THE PLATFORM
CONTROLS
CHECK THE FUEL
LEVEL
CHECK THE ENGINE
OIL LEVEL
CHECK THE COOLANT
LEVEL
CHECK THE HYDRAULIC
FLUID LEVEL