3 - 44
G6 - FRONT HEADLAMPS
ADJUST
RECOMMENDED SETTING
(As per standard ECE-76/756 76/761 ECE20)
Set to - 2% of the dipped beam in relation to the horizontal line of the headlamp.
ADJUSTING PROCEDURE
- Place the lift truck unloaded and in the transport position
and perpendicular to a white wall on flat, level ground (Fig.
G6).
- Check the tyre pressures (See chapter : A6 - TYRES
PRESSURE AND WHEEL NUTS TORQUE in paragraph :
3 - MAINTENANCE).
- Put the gear reverser lever in neutral and release the
parking brake.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (h2)
• h1 = Height of the dipped beam in relation to the ground.
• h2 = Height of the adjusted beam.
• l = Distance between the dipped beam and the white wall.
To Next Page
Loading...
