1 - 23
BRINGING THE LIFT TRUCK BACK INTO SERVICE
- Remove the waterproof adhesive tape from all the holes.
- Refit the intake hose.
- Refit and reconnect the battery.
- Remove the protection from the steering cylinder rods.
- Perform the daily service (See chapter : A - DAILY OR EVERY 10 HOURS SERVICE in paragraph : 3 - MAINTENANCE).
- Put the handbrake on and remove the axle stands.
- Empty and replace the fuel and replace the fuel filter (See chapter : D - EVERY 500 HOURS SERVICE in paragraph : 3 -
MAINTENANCE).
- Refit and set the tension in the drive belts (See chapter : C - EVERY 250 HOURS SERVICE in paragraph : 3 -
MAINTENANCE).
- Turn the internal combustion engine using the starter, to allow the oil pressure to rise.
- Reconnect the engine cut-off solenoid.
- Lubricate the lift truck completely (See chapter : SERVICING SCHEDULE in paragraph : 3 - MAINTENANCE).
Make sure the area is adequately ventilated before starting up the lift truck.
- Start up the lift truck, following the safety instructions and regulations (See chapter : OPERATING INSTRUCTIONS in
paragraph : 1 - OPERATING AND SAFETY INSTRUCTIONS).
- Run all the jib's hydraulic movements, concentrating on the ends of travel for each cylinder.
To Next Page
Loading...
Need help?
General
