fast idle button, rotate the control lever. Note that you can open the
throttle without shifting into gear. The fast idle button can only be
depressed when the engine shift lever is in neutral. Use caution with the
fast idle control.
Power Trim and Tilt Switch
The power trim and tilt switch is attached to the control lever grip. It is
operated using your thumb. Pushing the switch upward trims and tilts the
motor upward. Pushing the switch downward trims and tilts the motor
downward. While the trim and tilt switch is in use, the trim gauge located
on the instrument panel will indicate the angle of the propeller relative to
the hull. As you push the switch up or down, the gauge should reflect this
change.
Tips for Using the Shift and Throttle Control System
The following tips will aid you when you are using the shift and throttle
control system:
< When shifting between forward and reverse, always pause for a few
seconds in neutral before reversing the propeller. This will prevent
damage to the engine.
< When maneuvering at slow speed, you can reverse the propeller to
slow or stop the boat’s forward movement.
< When moving in reverse, gradually increase boat speed. Accelerating
at high speed while in reverse may create a wake that can flood the
stern area of your boat.
Please keep in mind that this information may not apply to your specific
shift and throttle control system. To learn more, read the shift and throttle
control owner’s manual enclosed with your Manitou owner’s packet.
You may also consult with your dealer or the engine manufacturer for
more information.
To Next Page
Loading...
Need help?
General
