Manitou M26-2 3-E2 Series - Page 120

3 - 17
A4 - CYCLONIC PREFILTER (OPTION)
CLEAN
The cleaning interval is given as a guide, however the prefilter must be emptied as soon
as impurities reach the MAXI level on the tank.
- Loosen nut 1 (fig. A4), remove cover 2 (fig. A4) and empty the tank.
- Clean the prefilter unit with a clean dry cloth and reassemble the unit.
When cleaning, take care not to let impurities into the dry air filter.
A5 - TRANSMISSION OIL LEVEL
CHECK
MC 30 Série 3-E2 M26-2 Série 3-E2 M26-4 Série 3-E2 M40-4 Série 3-E2
M30-2 Série 3-E2 M30-4 Série 3-E2 M50-4 Série 3-E2
Place the lift truck on level ground with the I.C. engine cold and at idle.
- Open the I.C. engine bonnet.
- Remove the dipstick 1 (fig. A5).
- Wipe the dipstick and check the level at the upper notch.
- If necessary, add oil (see: 3 - MAINTENANCE: E3 - TRANSMISSION OIL).
- Check visually that there is no leakage or seepage of oil in the transmission.
A5 - TRANSMISSION OIL LEVEL
CHECK
MC 40 POWERSHIFT Série 3-E2 MC 60 POWERSHIFT Série 3-E2
MC 50 POWERSHIFT Série 3-E2 MC 70 POWERSHIFT Série 3-E2
Place the lift truck on level ground with the I.C. engine cold and at idle.
- Disassemble the access panel 1 (fig. A5/1).
- Remove the dipstick 2 (fig. A5/2).
- Wipe the dipstick and check the level of the lower notch.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by the filler port 3
(fig. A5/2).
NOTE: OIL LEVEL WHEN COLD (between 15 °C and 20 °C), oil level must be at lower notch.
OIL LEVEL WHEN WARM (between 82 °C and 93 °C), oil level must be at upper notch.
- Check visually that there is no leakage or seepage of oil in the transmission.
Too much oil in the transmission may have a detrimental effect on the functioning of the lift
truck.
A5
A5/1
A5/2
1
1
2
3
A4
1
2