Manitou M30-4 3-E2 Series - Page 153

3 - 50
G6 - OVERHEAD GUARD OR THE CAB
LIFT
To be done in the event of major intervention on the
lift truck.
PLACING THE LIFT TRUCK
- Place the lift truck on level ground.
- Set the gear lever in 1st or 3rd gear (as model of lift
truck).
- Untighten the parking brake.
- Tilt the mast backwards to a maximum and if
necessary lift the mast so as to bring it
approximately 50 cm above the overhead guard or the cab.
FITTING THE CABLE
- Unscrew the two screws 1 (fig. G6/1) on the roof and replace them by two rings 2 (fig.
G6/2) MANITOU Reference 72422.
- Pass the cable onto the upper belt of the mobile upright and fasten the cable onto the
rings (fig. G6/3).
UNLOCKING THE OVERHEAD GUARD OR THE CAB
- Disassemble the side panels 3 (fig. G6/4) (3 fastening screws).
- Unscrew the fastening screws of the silent blocks 4 (fig. G6/5) and only remove the nuts.
- Close the left cab door.
- Open and immobilize the right door.
G6/1
G6/4
G6/5
G6/2
G6/3
1
1
2
3
3
4
4