3 - 39
E3 - TRANSMISSION OIL
DRAIN
E4 - TRANSMISSION HOUSING STRAINER
CLEAN
MC 30 Série 3-E2 M26-2 Série 3-E2 M26-4 Série 3-E2 M40-4 Série 3-E2
M30-2 Série 3-E2 M30-4 Série 3-E2 M50-4 Série 3-E2
Place the lift truck on level ground with the I.C. engine stopped, the transmission oil still
warm.
DRAINING THE OIL
- Remove cover plate 1 (fig. E3/1).
- Place a container under drain plug 2 (fig. E3/2) and under cover 3 (fig. E3/3) and unscrew
the drain plug.
- Remove dipstick 4 (fig. E3/4) and unscrew filling plug 5 (fig. E3/4) in order to ensure that
the oil is drained properly.
Dispose the drain oil in an ecological manner.
CLEANING THE STRAINER
- Remove cover 3 (fig. E3/3) and set aside the O-ring joint and sealing washer.
- Allow the rest of the oil to drain away.
- Remove and clean the strainer using a compressed air jet.
- Clean the magnetic section on the plate.
- Refit the assembly and tighten up plate 3 (fig. E3/3) (tightening torque 18 to 31 N.m).
FILLING UP THE OIL
- Refit and tighten drain plug 2 (fig. E3/2) (tightening torque 34 to 54 N.m).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by filler port 5 (fig. E3/4)
and refit the plug.
- Run the I.C. engine at idle speed ensure check the level at the upper notch on dipstick
4 (fig. E3/4).
- Check any possible leaks from the drain plug or cover.
- Top up the level if necessary.
- Put back the cover plate 1 (fig. E3/1).
E3/1
E3/2
E3/3
E3/4
2
3
4
5
6
1
To Next Page
Loading...
