3 - 40
E3 - TRANSMISSION OIL
DRAIN
MC 40 POWERSHIFT Série 3-E2 MC 60 POWERSHIFT Série 3-E2
MC 50 POWERSHIFT Série 3-E2 MC 70 POWERSHIFT Série 3-E2
Place the lift truck on level ground with the I.C. engine stopped, the transmission oil still
warm.
DRAINING THE OIL
- Place a container under drain plug 1 (fig. E3/1) and unscrew the plug.
- Disassemble the access panel 2 (fig. E3/2).
- Remove dipstick 3 (fig. E3/3) in order to ensure that the oil is drained properly.
Dispose the drain oil in an ecological manner.
FILLING UP THE OIL
- Refit and tighten drain plug 1 (fig. E3/1) (tightening torque 54 à 61 N. m).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by filler port 4 (fig. E3/3)
and refit the plug.
- Run the engine at idle speed, check the oil level (see: 3 - MAINTENANCE: A5 - CHECK THE
TRANSMISSION OIL LEVEL) and any possible leaks.
- Reassemble the access panel 2 (fig. E3/2).
E3/1
E3/2
E3/3
1
2
3
4
To Next Page
Loading...
