Manitou MI 30 D - EVERY 250 HOURS OF SERVICE

3-20
C - EVERY 250 HOURS OF SERVICE
Carry out the operations described previously as well as the following operations.
C1 - TRANSMISSION OIL LEVEL
CHECK
Place the lift truck on level ground with the engine stopped.
- Raise the engine cover (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Remove the floor mat.
- Undo screws 1 (fig. C1/1) to remove the floor 2 (fig. C1/1).
- Remove dipstick 3 (fig. C1/2).
- Wipe the dipstick and check the correct level between the MINI and MAXI marks.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through the filler port 4
(fig. C1/3).
- Visually check that there is no leakage or seepage of oil from the transmission.
C2 – DIFFERENTIAL OIL LEVEL
CHECK
Place the lift truck on level ground with the engine stopped.
- Remove level plug 1 (fig. C2). The oil should be flush with the edge of the hole.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through the same hole.
- Replace and tighten the level plug 1 (fig. C2).
C1/2
3
C1/3
4
C1/1
2
1
1
C2
1
647377 (31/03/2014)