3-23
D2 - ENGINE OIL
DRAIN
D3 - ENGINE OIL FILTER
CHANGE
MI 15 D / MI 18 D
MI 20 D / MI 25 D
MI 30 D / MI 35 D
Place the lift truck on level ground, let the engine run at idle for a few minutes, then stop the
engine.
DRAINING THE OIL
- Raise the engine cover (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Place a container under drain plug 1 (fig. D2/1) and unscrew the plug.
- Remove filling plug 2 (fig. D2/2) in order to ensure that the oil is drained properly.
Dispose of the drain oil in an ecological manner.
REPLACEMENT OF THE FILTER
- Remove engine oil filter 3 (fig. D2/3) and discard the filter and the filter seal.
- Clean the filter mount with a clean, lint-free cloth.
- Lightly grease the new oil filter seal and fit the new oil filter (see: 3 - MAINTENANCE: FILTERS
CARTRIDGES AND BELTS) on the filter bracket.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
FILLING UP THE OIL
- Refit and tighten drain plug 1 (fig. D2/1).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) by filler port 4 (fig. D2/2).
NOTE: For this operation, we recommend you use a funnel fitted with a hose.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks at the drain plug and the oil filter.
- Stop the engine, wait a few minutes and check the level between the MAX and MIN marks on
dipstick 5 (fig. D2/3).
- Top up the level if necessary.
D2/1
1
D2/2
2
4
D2/3
3
5
To Next Page
Loading...
