Manitou MI 30 D - Page 94

3-34
F2 - FUEL TANK
CLEAN
While carrying out these operations, do not smoke or work near a flame.
Place the lift truck on level ground with the engine stopped.
- Inspect the parts susceptible to leaks in the fuel circuit and in the tank.
- In the event of a leak, contact your dealer.
Never try to carry out a weld or any other operation by yourself, this could provoke an explosion or a fire.
- Place a container under drain plug 1 (fig. F2/1) and unscrew the plug.
- Remove filling plug 2 (fig. F2/2) in order to ensure that the oil is drained properly.
- Rinse out with ten litres of clean diesel through the filler port.
- Refit and tighten the drain plug (tightening torque 29 to 39N.m).
- Fill the fuel tank with clean diesel filtered through the filling port (see: 3 - MAINTENANCE:
LUBRICANTS AND FUEL).
- Refit the filler plug.
- If necessary, bleed the fuel system (see: 3 - MAINTENANCE: G – OCCASIONAL MAINTENANCE).
F3 - DIFFERENTIAL OIL
DRAIN
Place the lift truck on level ground with the engine stopped and the d oil still warm.
Dispose of the drain oil in an ecological manner.
- Place a container under drain plug 1 (fig. F3/1) and unscrew the plug.
- Remove level and filling plug 2 (fig. F3/2) in order to ensure that the oil is drained properly.
- Refit and tighten drain plug 1 (fig. F3/1).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through filling port 2 (fig. F3/2).
- The level is correct when the oil level is flush with the edge of the hole.
- Check for any possible leaks at the drain plug.
- Refit and tighten level and filling plug 2 (fig. F3/2).
F4 - WHEEL NUTS TIGHTENING TORQUE
CHECK
- Check the tightening torque of the wheel nuts with a torque wrench.
Wheel nut tightening torques
• Front wheels: 157-176 N.m MI 15 D / MI 15 G / MI 18 D / MI 18 G
441-588 N.m MI 20 D / MI 20 G / MI 25 D / MI 25 G / MI 30 D / MI 30 G / MI 35 D / MI 35 G
• Rear wheels: 157-176 N.m
F3/2
F3/1
1
2
F2/1
1
F2/2
2
647377 (31/03/2014)