EasyManuals Logo

Manitou MLT 730 User Manual

Manitou MLT 730
177 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
3 - 44
G6 - FRONT HEADLAMPS
ADJUST
RECOMMENDED SETTING
(As per standard ECE-76/756 76/761 ECE20)
Set to - 2% of the dipped beam in relation to the horizontal line of the headlamp.
ADJUSTING PROCEDURE
- Place the lift truck unloaded and in the transport position
and perpendicular to a white wall on flat, level ground (Fig.
G6).
- Check the tyre pressures (See chapter : A6 - TYRES
PRESSURE AND WHEEL NUTS TORQUE in paragraph :
3 - MAINTENANCE).
- Put the gear reverser lever in neutral and release the
parking brake.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (h2)
h1 = Height of the dipped beam in relation to the ground.
h2 = Height of the adjusted beam.
l = Distance between the dipped beam and the white wall.
h1
+%
-%
l
h1
h2
-2%
h2 = h1 - (l x 2 / 100)
G6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MLT 730 and is the answer not in the manual?

Manitou MLT 730 Specifications

General IconGeneral
BrandManitou
ModelMLT 730
CategoryFront End Loaders
LanguageEnglish

Related product manuals