EasyManua.ls Logo

Manitou MRT EASY 55P 400 ST4 S2 - Page 44

Manitou MRT EASY 55P 400 ST4 S2
316 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-36
IT EN NL
PUTTING THE MACHINE BACK
INTO OPERATION
Before restarting work after a prolonged
lay-off, proceed as follows:
- Replace the battery, after recharging.
- Check the tyre pressure.
- Clean the machine to remove the protec-
tive grease.
- Check all lubricant levels and top up if
necessary.
- Change the combustion air filter.
- Grease all components fitted with grease
nipples.
- Start the engine and run it idle for about
ten minutes.
- Operate the machine without load and
check all movements.
- Have the rotary electrical slip rings
checked and cleaned (after 3 months of
shutdown)
Contact your agent or dealer.
RIMESSA IN SERVIZIO DELLA
MACCHINA
Prima di riprendere il lavoro dopo una
lunga inattività è necessario:
- Rimontare la batteria, dopo averla ricari-
cata.
- Controllare la pressione dei pneumatici.
- Pulire la macchina dal grasso di protezio-
ne.
- Controllare tutti i livelli dei lubrificanti ed
eventualmente rabboccare.
- Sostituire il filtro dell’aria di combustione.
- Ingrassare tutti gli organi provvisti di
ingrassatori.
- Avviare il motore della macchina e farlo
funzionare a vuoto per una
decina di minuti.
- Far funzionare la macchina a vuoto e veri-
ficare tutti i movimenti.
- Far controllare e pulire gli anelli trasmet-
titori del collettore elettrico rotante (dopo
3 mesi di inattività)
Rivolgersi al Vostro agente o concessionario.
DE HEFTRUCK WEER IN BEDRIJF
STELLEN
Voor het werk te hervatten na een lange
periode dat de heftruck niet gebruikt is:
- Monteer de accu weer na hem opgeladen
te hebben.
- Controleer de bandenspanning.
- Verwijder het beschermvet van de hef-
truck.
- Kijk alle smeermiddelniveaus na en vul ze
eventueel bij.
- Vervang het verbrandingsluchtfilter.
- Vet alle onderdelen in die voorzien zijn
van smeernippels.
- Start de motor van de machine en laat
hem stationair draaien
gedurende een tiental minuten.
- Laat de machine onbelast werken en con-
troleer alle bewegingen.
- Laat de transmissieringen van de roteren-
de elektrische collector controleren en
schoonmaken (na 3 maanden stilstand)
Neem contact op met uw agent of dealer.
649050 IT-EN-NL (01/06/2017)
MRT EASY 55P 400 ST4 S2, MRT EASY 55P 360 ST4 S2, MRT EASY 75P 400 ST3B S2, MRT EASY 75P 360 ST3B S2, MRT-X EASY 75P 400 ST3A S2, MRT-X EASY 75P 360 ST3A S2

Related product manuals