Manitou MSI 30 D - Page 81

3 - 7
E - EVERY 800 WORKING HOURS SERVICE
To be carried out once a year if the lift truck has not reached the 800 hours service in the year.
E1 - Drain and change the hydraulic oil.
E2 - Clean the suction strainer of the hydraulic oil tank.
E3 - Change the hydrostatic transmission oil filter cartridge.
E4 - Drain and change the cooling liquid.
E5 - Drain and clean the fuel tank.
E6 - Change the safety dry air filter cartridge.
E7 - Check the brake circuit pressure (*).
E8 - Check the brake adjustment (*).
E9 - Check the engine silentblocs (*).
E10- Check the engine speeds (*).
E11- Check the attachment carriage (*).
E12- Check the condition of the wheels and tyres (*).
E13- Check the speeds of the hydraulic movements (*).
E14- Check the condition of the attachments (*).
E15- Clean the hydraulic pump tubular filter (*).
E16- Clean the brake solenoid valve filter (*).
E17- Check the injectors (*).
E18- Check and adjust the valves clearances (*).
(*) : (Consult your dealer).
F - EVERY 2400 WORKING HOURS SERVICE
F1 - Drain and change the front wheel reducer oil.
(This operation should be carried out once a year if the lift truck has not reached 2400
hours service within the year).
F2 - Check the hydraulic circuit pressures and discharge rates (*).
F3 - Check the hydrostatic transmission circuit pressures (*).
F4 - Check and adjust the governing start r.p.m. of the hydrostatic transmission (*).
F5 - Check the chain roller wear (*).
F6 - Check the mast guide rolls (*).
F7 - Check the mast bearing rollers (*).
F8 - Check the mast lifting chains (*).
F9 - Check the thickness of the mast wearing plates (*).
F10 -
Check the working order of the hydraulic valves for the transmission cut-off and accelerator (*).
F11 - Check the steering system (*).
F12 - Clean the hydraulic oil tank (*).
F13 - Check the oscillation of the rear axle (*).
F14 - Check and scale the radiator (*).
F15 - Check the water pump and the thermostat (*).
F16 - Check the condition of the mast assembly (*).
F17 - Check the alternator and the starter motor (*).
(*) : (Consult your dealer).
G - EVERY 4800 WORKING HOURS SERVICE
G1 - Check the wear of the brake disks (*).
G2 - Check the steering axle (*).
(*) : (Consult your dealer).
3 - 22
3 - 22
3 - 22
3 - 23
3 - 25
3 - 25
3 - 26