1 - PNEUMATIC DRIVER'S SEAT (OPTION)
FOR MAXIMUM COMFORT, THIS SEAT CAN BE ADJUSTED AS FOLLOWS.
WEIGHT ADJUSTMENT (FIG. A)
It is advisable to adjust the seat according to your weight while sitting.
- Switch on the lift truck ignition.
- Pull or push lever 1 briefly. Adjustment is automatic.
NOTE: To avoid any health problems, it is recommended that the weight should be checked
and adjusted before starting the lift truck.
SEAT HEIGHT ADJUSTMENT (FIG. B)
When weight adjustment has been carried out, you can then alter the seat height.
- Keep the ignition switched on.
- Push or pull lever 1 to adjust the height of the seat.
To avoid causing any damage, do not operate the compressor for over 1 minute.
SEAT BACK-REST ANGLE ADJUSTMENT (FIG. C)
The back-rest angle of the seat may be adjusted to suit the individual.
- Press the left-hand button while pushing on the seat or relaxing pressure on the seat to
find a comfortable position.
SEAT DEPTH ADJUSTMENT (FIG. D)
The depth of the seat may be adjusted to suit the individual.
- Press the right-hand button while raising or lowering the seat to find the desired position.
EXTENDING THE HEAD-REST (FIG. E)
- The height of the back-rest can be adjusted by pulling it upwards (the notches will be
heard clicking) up to the stop.
- The head-rest can be removed by applying sufficient pressure to pull it off the stop.
LUMBAR ADJUSTMENT (FIG. F)
This increases the comfort of the seat and the driver’s freedom of movement.
- Press the raise and lower switches to adjust the curvature of the seat back to your
requirements.
C
A
B
D
FE
2 - 18
To Next Page
Loading...
Need help?
General
