Manitowoc AUCS Q - Changing Switch Position During Automatic Operation; Q1400 C

Ice Machine Operation Section 3
3-2
Changing Switch Position During Automatic Operation
Q MODELS/IB MODELS/SU1000C
If the toggle switch is moved to OFF prior to the
pump dispensing (less than 45 seconds into the cycle)
then switched to:
ICE
A normal ice-making mode begins.
CLEAN
A manual clean cycle begins.
(See “Manual Start Operation,” page 3-1.)
If the toggle switch is moved to OFF after the pump
dispenses (more than 45 seconds into the cycle, but
before rinse cycles begin) then switched to:
ICE
The “clean” portion of the cycle begins.
After completion of the 10-minute
“Clean” and 6 rinse cycles, the counter
resets and a normal ice-making mode
begins.
CLEAN
A manual clean cycle begins.
(See “Manual Start Operation,” page 3-1.)
After completion of the 10-minute
“Clean” and 6 rinse cycles, the counter
resets and the ice machine awaits a
change in the toggle switch position.
If the toggle switch is moved to OFF after the 6 rinse
cycles have begun and then switched from off to:
ICE
The rinse portion of the cycle restarts and
continues.
After completion of the 6 additional rinse
cycles, the counter resets and a normal
ice-making mode begins.
CLEAN
A manual clean cycle begins.
(See “Manual Start Operation”.)
After completion of the 10-minute
“Clean” and 6 rinse cycles, the counter
resets and the ice machine awaits a
change in the toggle switch position.
Q1400C
If the toggle switch is moved to OFF prior to the
pump dispensing (less than 45 seconds into the cycle)
then switched to:
ICE
A normal ice-making mode begins.
CLEAN
A manual clean cycle begins.
(See “Manual Start Operation,” page 3-1.)
If the toggle switch is moved to OFF after the pump
dispenses (more than 45 seconds into the cycle, but
before rinse cycles begin) then switched to:
ICE
The ice machine runs 6 rinse cycles, resets
the counter and starts a normal ice-
making mode.
CLEAN
A manual clean cycle begins.
(See “Manual Start Operation”)
After completion of the 10-minute
“Clean” and 6 rinse cycles, the counter
resets and the ice machine awaits a
change in the toggle switch position.
If the toggle switch is moved to OFF after the 6 rinse
cycles have begun and then switched from off to:
ICE
The ice machine runs 6 rinse cycles, resets
the counter and starts a normal ice-
making mode.
CLEAN
A manual clean cycle begins.
(See “Manual Start Operation”.)
After completion of the 10-minute
“Clean” and 6 rinse cycles, the counter
resets and the ice machine awaits a
change in the toggle switch position.
Important
After solution is dispensed (cleaner or sanitizer),
the Q1400C ice machine must run 6 rinse cycles.
Changing toggle switch position, disconnecting
power, etc will not override the 6 rinse cycles.
Each time the toggle switch is moved from Off to
Ice (or power is interrupted), the six rinse cycles
begin again.