Part Number STH025 11/16 41
Step 1 Open the front door to access the evaporator
compartment. Ice must not be on the evaporator during
the clean/sanitize cycle. Follow one of the methods
below:
• Press the power switch at the end of a harvest cycle
after ice falls from the evaporator(s).
• Press the power switch and allow the ice to melt.
,
Caution
Never use anything to force ice from the evaporator.
Damage may result.
Step 2 Remove all ice from the bin/dispenser.
Step 3 Press the clean switch. Water will flow through
the water dump valve and down the drain. Wait until the
water trough refills and the display indicates add solution
(approximately 1 minute), then add the proper amount of
ice machine cleaner.
Model Amount of Cleaner
I0300/I0320/I0520 3 ounces (90 ml)
I0450/I0500/I0600/I0606/I0850
I0906/I1000/I1106/I1200
5 ounces (150 ml)
I1400/I1406/I1800 9 ounces (265 ml)
To Next Page
Loading...
Need help?
General