9-7
CONFIGURATION 5 – REAR MOUNT (69’, 90’, 103’
BOOMS)
This configuration allows the rear mount installa-
tion of the Series 900A. This configuration is 360° stable
and allows the effective use of close working area to lift
the heavier capacity loads.
Requires a 16,000 lb (7257 kg) GAWRF, 40,000 lb
(18 143 kg) GAWRR and 56,000 lb (25 401 kg) GVWR,
overframe outriggers, rear stabilizer, and heavy duty rear
mount sub-base. The maximum bed length is 16' (4.87
m). Counterweight may have to be added to ensure
unit stability if the truck does not meet minimum weight
requirements. Truck frame must have 15.9 in
3
(260 cm
3
)
section modulus and 1,749,000 in-lb (197 610 N·m) RBM
from rear of crane through the front outriggers. Truck
frame must have or be capable of being lengthened to
an AF of 112 inches (2844 mm).
*Actual scale weights prior to installation of crane,
heavy duty sub-base and behind cab stabilizers.
CONFIGURATION 6 – REAR MOUNT (125’ BOOM)
This configuration allows the rear mount installa-
tion of the Series 900A. This configuration is 360° stable
and allows the effective use of close working area to lift
the heavier capacity loads.
Requires a 18,000 lb (8165 kg) GAWRF, 40,000 lb
(18 143 kg) GAWRR and 56,000 lb (25 401 kg) GVWR,
overframe outriggers, rear stabilizer, and heavy duty rear
mount sub-base. The maximum bed length is 18' (5.5
m). Counterweight may have to be added to ensure
unit stability if the truck does not meet minimum weight
requirements. Truck frame must have 15.9 in
3
(260 cm
3
)
section modulus and 1,749,000 in-lb (197 610 N·m) RBM
from rear of crane through the front outriggers. Truck
frame must have or be capable of being lengthened to
an AF of 120 inches (3048 mm).
*Actual scale weights prior to installation of crane,
heavy duty sub-base and behind cab stabilizers.
360°
FULL CAPACITY
360°
FULL CAPACITY
Reference Only
To Next Page
Loading...
