Need help?Do you have a question about the Manitowoc SD0602A and is the answer not in the manual?
General| Ice Type | Cube |
|---|---|
| Condenser Type | Air-Cooled |
| Width | 30 inches |
| Type | Modular |
| Voltage | 115V |
| Refrigerant | R404A |
Lists all covered ice machine models and their configurations.
Explains the structure and meaning of ice machine model identifiers.
Details the different ice cube shapes available for the machines.
Guides users to find critical identification details on the ice machine.
Indicates changes in energy efficiency based on serial number ranges.
Outlines warranty coverage details and the registration process.
Criteria for selecting an optimal installation site for the ice machine head.
Specifies necessary space around the unit for proper operation and servicing.
Details the thermal output for HVAC considerations and installation planning.
Guides the proper installation of line sets for remote condensers.
Provides formulas and steps for determining optimal line set lengths.
Step-by-step instructions for properly connecting refrigerant line sets.
Identifies key components and their locations in single evaporator units.
Identifies key components and their locations in quad evaporator units.
Outlines periodic cleaning and general upkeep for efficient operation.
Step-by-step guide for regular cleaning and sanitizing of the ice machine.
Specific instructions for units experiencing significant scale buildup.
Instructions for disassembling evaporator models for cleaning procedures.
Special precautions for extended non-use or exposure to freezing temperatures.
Procedure for preparing self-contained air-cooled models for storage.
Procedure for preparing water-cooled models for storage.
Procedure for preparing remote ice machine models for storage.
Describes the operational cycles for self-contained air/water-cooled units.
Explains the function of non-adjustable safety timers in the control system.
Details the safety limit controls that protect against major component failures.
Explains the automated rinse cycle that initiates after a set number of cycles.
Diagnosing issues related to safety limit controls and indications.
Guidance on diagnosing the root cause of safety limit trips and machine stops.
Guides users to solutions based on observed operational problems.
Addresses issues specifically encountered during the ice harvest phase.
Procedures for testing key electrical components like fuses and switches.
Detailed checks for compressor starting, overload, and winding issues.
Procedures for testing critical refrigeration system parts.
Procedures for safely recovering and evacuating refrigerant from the system.
Steps for restoring systems affected by moisture or compressor burnout.
Provides the electrical rating for the main fuse.
Details the cut-in and cut-out pressure settings for fan cycle controls.
Specifies the cut-in and cut-out pressure settings for HPCO controls.
Lists recommended OEM filter-drier part numbers and sizes for replacement.
Table listing the correct refrigerant amounts required per model.
Guidelines for verifying correct ice machine operation and performance.
Performance data including cycle times and operating pressures for S300 models.
Performance data including cycle times and operating pressures for S1400 models.
Performance data including cycle times and operating pressures for S1800 models.
Performance data including cycle times and operating pressures for S3300 models.
Electrical schematics illustrating the wiring for various ice machine models.
Electrical schematics specific to energy-efficient and EnergyStar models.
Schematics detailing the connections and indicators on the electronic control board.
Diagrams illustrating the refrigerant flow paths within the system.
To Next Page
