Need help?Do you have a question about the Mannesmann REXROTH A11VO 60 LRDS and is the answer not in the manual?
General| Series | A11VO |
|---|---|
| Size | 60 |
| Control | LRDS |
| Displacement | 60 cm³/rev |
| Maximum Pressure | 350 bar |
| Shaft Type | Spline shaft |
| Weight | Approximately 32 kg (depending on configuration) |
Instructions for inserting the bearing shells.
Procedure for cleaning all threaded borings.
Install bearings with wire guide and secure with auxiliary device.
Examples of auxiliary devices like clamps and grease.
Place swivel cradle with bearing into bearing shell, mind installation position.
Remove auxiliary devices and check bearing seats.
Mount shims, springs, and retaining ball, note mounting position.
Procedure for installing the large hydraulic control rod.
Adjust guide wire, install joint pins, and locking screws.
Place retaining plate with piston into the cylinder.
Secure swivel cradle with threaded pin in zero position.
Assembly hint to fix pistons using an O-ring.
Procedure for installing the drive shaft.
Procedure for inserting the fixing segments.
Procedure for mounting the cover ring.
Install screws with Loctite, mind hardening time, and tighten to torque.
Torque values for shaft bolts with metric ISO standard thread.
Torque values for locking screws with metric ISO fine thread.
Torque values for seal-lock nuts with metric ISO standard thread.
Torque values for cross-slotted lens head screws DIN 7985.
To Next Page
