Manntek DCC - Transport and Storage; Delivery Checks and Returns; Storage Guidelines; Installation Procedures

7 of 10 - Version 181002
Change the O-ring (pos 3) on the piston. Make sure
that the O-ring doesn’t get scratches when
mounting.
Reassemble the inner package.
Reasemble the piston o the piston guide, make
sure that the splint (pos 63) is correct mounted.
If necessary change the three shafts (pos.18),
locking nuts (pos.19) and rollers (pos.17) to new
ones.
Tool: Standard wrench 13 mm
Check the rollers for easy rotation.