USER’S MANUAL
9
PM time is indicated by the PM light. −
Press the MINUTE SET BUTTON (4) until the correct time appear −
on the clock display.
Release the buttons as time is set precisely.
TO SET WAKE TO ALARM
Slide the ALARM AUTO/OFF SWITCH (1) to „AUTO” position. −
Press and hold down the ALARM SET BUTTON (5), and while this −
button is depressed, press the HOUR SET BUT TON (3) and then the
MINUTE SET BUTTON (4) until it reaches the time which you wish
to wake up. The wake up time is entered in its memory.
Release the ALARM SET BUTTON (5). −
The alarm will switch on automatically at the pre-set wake up
−
time.
You can check the pre-set wake up time by pressing the ALARM SET
BUTTON (4) at any time.
NOTE:
This pre-set wake-up time will remain or continue to be restored in
the time memory as long as the clock is connected to the power supply,
and the Alarm will switch on by itself at the same time next day.
SNOOZE CONTROL AND TO STOP THE
ALARM
Press the SNOOZE BUTTON (7) to stop the Alarm for a while,
−
however, it will repeat after 9 minutes.
To switch the Alarm off on that day, press the ALARM OFF BUTTON
−
(6). Nevertheless, the Alarm will switch on automatically at the
pre-set wake up time on the next day.
EN
To Next Page
Loading...
Need help?
General