USER’S MANUAL
8
POWER SUPPLY
Please check that the mains electricity power supply is the same as
the AC rating indicated on the label on the base of the clock.
INSTALLATION
This unit operates in AC mains power supply. It also has a built-in
−
battery backup facility, which keeps the electronics clock wor-
king in the event of temporary power failure or disconnection
from the mains.
Place one 9 volt alkaline battery (type 522 or equivalent) into
−
the battery compartment (located in the bottom of unit) and
connect the corresponding terminals, (battery not included). Set
the ALARM AUTO/OFF SWITCH (1) to „OFF” position.
Plug the AC line cord to a CONVENIENT AC power outlet and switch
−
it on. The clock will flash on and off until it has been set correctly.
Flashing will also occur if the power supply is interrupted when
no battery is installed, or the battery is exhausted.
IMPORTANT
Do not install the clock where it can fall, or be pulled or pushed into
water. Never reach for an appliance after it has fallen into water. Switch
off at the power point and unplug immediately.
SETTING THE NORMAL TIME
Hold down the TIME SET BUTTON (2) −
Press the HOUR SET BUTTON (3) until the correct hour is shown −
on the clock display.
NOTE: −
EN
To Next Page
Loading...
Need help?
General