EN
3
BOARD CALIBRATION
The board should be calibrated preferably right after unpacking, before its
first use.
The calibration is necessary to set the gyro-sensors, which might have
been deranged during the transport if impacted, appropriately.
Performing calibration:
Place the board on a plain flat surface.
Make sure that the board is off.
Using a cross-level, level both wheels simultaneously. It is of utmost
importance that both wheels are levelled evenly and simultaneously. See
the figure:
After making sure that both wheels are properly levelled, press POWER
button and hold it for 5 seconds until blue diodes start to flash.
The board will be calibrated when the diodes stop flashing.
Turn it off, then again on, and it will be ready to use.
To Next Page
Loading...
Need help?
General
