What to do if my mantona Turnaround 360 Camera Accessories device is on but not working?
If your mantona Camera Accessories device switches on but doesn't function, the battery may not be sufficiently charged, so charge the battery. If charging doesn't resolve the issue, the device could be defective, or the device has fallen or been dropped, so you should contact the manufacturer or have the device checked by an electrician.
General| Brand | mantona |
|---|---|
| Model | Turnaround 360 |
| Category | Camera Accessories |
| Language | English |
Identifies symbols and markings used on the device and in the manual for safety and operational guidance.
Explains the meaning of specific icons like WARNING, CAUTION, and NOTE used within the instruction manual.
Ensures secure hold of attached devices and checks all locks, screws, and fastening elements before use.
Warns about short-circuits from defective cables, humidity, and advises against operating with wet hands or feet.
Keeps the device out of reach of children and pets due to small parts.
Provides safety notes on handling the integrated rechargeable battery to prevent swelling or explosion.
Details all components and control elements of the tripod head with numerical references.
Lists the essential steps for first-time device use to prevent damage, including charging and setup.
Instructions on how to charge the internal battery using a USB cable and power supply.
Steps for securely attaching the tripod head to a tripod using the appropriate thread connector.
Guidance on screwing the recording device onto the automatic head's connection thread.
Procedure for turning the device on and off using the power button.
Refers to the section on switching the device on for operation.
Instructions on using the operating knob to set the desired rotation angle between 15° and 360°.
How to use the 'R.T.' button to select the desired rotation duration from 5 to 60 minutes.
Procedure to set the rotation direction (clockwise or anticlockwise) using the 'DIR' LED indicator.
Pressing the start/stop button to initiate the rotation process.
Pressing the start/stop button to halt the rotation process.
To Next Page
