MFS110 is a high-quality USB optical fingerprint
sensor. Hard optical sensor is resistant to scratches,
impact, vibration, & electrostatic shock. MFS110
can be used for authentication, identification &
ver i fi c ation fun c t ions. Con g ratulation s on
purchasing MFS110, Which is designed specially to
provide high-level biometric security for desktops
as well as complex network environments.
Position of Finger
Introduction
Finger Height :
Finger Angle :
st
Align center of 1 phalanx with sensor center
The finger must be parallel to sensor sides
Finger Inclination :
Finger must be parallel to the sensor surface
Finger Rotation :
Finger must be parallel to the sensor surface
Warranty Terms
6. Maximum Liability of company under or in connection with the product, for
any reason and on any basis whatsoever, is limited to fifty percent (50 %) of the
total amount of the product.
7. In the event of repairs of any part/s of the unit, this warranty will thereafter
continue and remain in force only for the unexpired period of the warranty. The
period for repair and in transit whether under the warranty or otherwise shall not
be excluded from the warranty period.
5. The company shall not be liable for any direct, indirect or consequential loss,
damage, cost or expense of any kind, whether arising from tort, breach of
contract or howsoever, including without limitation loss of profits or of contracts,
loss of operation time and loss of goodwill or anticipated savings.
8. In case of any damage to the product/misuse detected by the authorized
service center personnel, the warranty conditions are not applicable and repairs
will be done subject to availability of parts and on a chargeable basis only.
9. In the event of any unforeseen circumstance, and spares not being available,
the company’s prevailing depreciation rules will be binding on the purchaser to
accept as a commercial solution in lieu of repairs.
10. The warranty does not cover the cost of transportation of the system from the
place of installation to the Service Center.
2. Repairs under warranty period shall be carried out by the company authorized
personnel only. The details of service centers/support required are available at
the company website www.mantratec.com/Support or in the centralized
helpline (+917949068000 - EXT: 1).
4. The company does not undertake responsibility for the quality of software
being used by the purchaser.
1. The warranty is confined to the first purchaser of the product only and is not
transferable.
3. Tenure of Warranty and process for claiming warranty shall be as per the
original Tax Invoice of the company.
Rights and Obligations : User guarantees that the product will not be used in
any way that violates the law or legal rights of any third party (including but not
limited to Intellectual Property Rights, privacy rights, and portrait rights). In case
of violation, the user shall bear the legal liabilities and other responsibilities
arising therefrom.
Operating & Handling Instructions
u Disconnect the sensor from your desktop when not operating.
u Operate the sensor within the operating limits specified.
u Use only the USB cable provided & don't attempt to replace it.
u Handle the sensor with proper care to avoid damage of the sensor.
u Clean the glass portion (Platen Area) of the sensor with the cleaning cloths
to avoid latent fingerprint detection or rejection.
u Store the sensor in a cool & dry place when not in use.
u If the sensor does not work make sure the sensor is detected as “Mantra
fingerprint : MFS110” in the device manager of PC. If the sensor is not
detected, please re-install the drivers for proper functioning of the
sensor. In case of further problem please contact technical support
person for assistance.
u In windows, Driver must be installed before using your USB Fingerprint
sensor, a Driver is automatically detected when you plug the sensor into
the USB port of your PC.
u Finger must be parallel to sensor surface.
Any damage to the device caused by these activities will void the warranty.
To Previous Page
Loading...