11
This electric pressure cooker comprises of two major
components namely:
a. Electric unit (plastic base) housing the Micro
processor control system
b. Stainless Steel pressure cooker with an attached
base protecting the heater coil
a. Electric unit (plastic Base) : This houses the
power connections, all the electronics for the
programmable controller, the electrical interlocks and
the over temperature thermal cutout. The pressure
cooker base (skirt), which protects the coil, has to be
positioned in this plastic base unit properly in the
groove provided in the base. The column contains the
micro controller circuit for time and power control.
This also has 3 buttons one below the other and a LED
status indicator for “POWER ON” function and the 2
digits display which displays in minutes the set time
during programming and the remaining time during
operation.
Once the pressure cooker is loaded with the required
food stuff and recommended quantity of water, close
the cooker and lock it properly as per the instructions
given under section ”How to use your programmable
electric multi cooker” (Page No. 12). While placing
the cooker on the plastic base ensure that it is properly
positioned in such a way that the projection on the skirt
of the cooker body is aligned with the corresponding
slot in the plastic base. This will automatically align
the heater terminals with the mating connector in the
plastic base. In this position, the marking “FRONT”
on the body will be facing the back of the control
column or facing you. The plug of the supplied cord
has to be securely connected to the power socket (wall
outlet).
The right most bottom corner decimal point LED of
the 2 digits display and the “POWER ON” mode LED
on the column will both be off. The 2 digits LED
indicator over the SET button (First from the top) will
DESCRIPTION OF PARTS AND FUNCTIONS
To Next Page
Loading...