Maplin N73CG - Maintenance and Safety; Battery and Fuse Replacement; General Caution; Critical Safety Warning

5
BATTERY AND FUSE REPLACEMENT
The fuse rarely needs replacement and blows almost always as a result
of operator error.
If "BAT" appears on display, it indicates that the battery should be
replaced.
To replace the battery and fuse (200mA/250V) remove the 2 screws in
the bottom of the case. Simply remove the old, and replace with a new
one. Be careful to observe battery polarity.
CAUTION
Before attempting to open the case of the instrument, be sure to
disconnect test leads from any energized circuits to avoid shock hazard.
ACCESSORIES
· Operator's instruction manual
· Set of test leads
· K type thermocouple
· 9 volt battery, PP3, NEDA 1604 6F22 TYPE (Optional).
READ AND UNDERSTAND THIS MANUAL
BEFORE USING THE INSTRUMENT.
Failure to understand and comply with the
WARNINGS and operating instructions
can result in serious or fatal injuries and/or
property damage.
WARNING