Statements
This product complies with Part 15 of the FCC rules and with the Industry Canada license-exempt RSS-standards. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Features
Personal Identification: Four permanent PINs and one temporary PIN can be stored. Each PIN has to be programmed into the garage door opener
(GDO). All of the PINs have four digits, which can be free chosen and which can be changed at any time. After entering a valid PIN and pressing the
ENTER button, a corresponding telegram is sent to the GDO. The keypad remains active for further actions for additional 25 seconds. Within this
interval, the keypad can be used without re-entering the PIN. As long as the keypad is in stand-by mode, it is not possible to control a second GDO.
Temporary PIN: This restricted PIN can be used for a maximum of 99 opening operations. The PIN as well as the number of opening operations can
be set and/or changed individually.
"One-button-close" function: This function can be activated and deactivated on the keypad. By pressing the ENTER key, all garage doors that are
associated with the Wireless Keyless Entry System are closed without the need for entering a PIN. The "One-button-close" function cannot be used
during the 25-second stand-by interval. The close command applies to all GDO’s, i.e. all garage doors are closed simultaneously by pressing the
ENTER key.
Keypad illumination: Pushing up the cover or pressing any key causes the keypad to light up for 5 seconds. Any further pressing of the keypad
buttons prolongs the illumination time by 5 more seconds.
Light function: By pressing the LIGHT button followed by the ENTER button, an external lighting or similar device can be switched on and off by
radio.
Transmitter-programmes-transmitter function: This function is performed wirelessly. Saved PINs are overwritten, i.e. if 4 PINs have already been
saved, programming a 5th PIN will overwrite the first PIN (e.g. 1-2-3-4).
"Low-Battery" check: This occurs immediately when pushing up the cover. If a Low Battery state is recognized, the keypad illumination starts to
flash for 10 secs.
Factory settings: The keypad is pre-programmed with the PIN "1-2-3-4" and can be teached directly into a GDO. The "One-button-close" function is
enabled.
To Next Page
Loading...