EasyManua.ls Logo

Marantz NA-7004 User Manual

Marantz NA-7004
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
- 1 -
MARANTZ SYSTEM control protocol
Application model :
NA-7004
Application terminal: RS-232C/ Ethernet
Connector specification
. RS-232C
Connector type: DB-9pin female type, slave straight connection (DCE type)
( 1pin : GND , 2pin : TxD , 3pin : RxD , 5pin : Common(GND) , 4,6,7,8,9pin : NC )
Communication format:
Synchronous system : Tone step synchronization
Communication system : A half duplex
Communication speed : 9600bps
Character length : 8 bits
Parity control : None
Start bit : 1 bit
Stop bit : 1 bit
Communication procedure : Non procedural
Communication data length : 135 bytes (maximum)
Question and Answer IconNeed help?

Do you have a question about the Marantz NA-7004 and is the answer not in the manual?

Marantz NA-7004 Specifications

General IconGeneral
BrandMarantz
ModelNA-7004
CategoryAccessories
LanguageEnglish

Summary

Network Setup for NA7004

Network Setup Procedure

Step-by-step guide for configuring network settings like DHCP, IP address, Subnet Mask, and Gateway.

Network Standby Mode Option

Explains how to set network standby mode to reduce power consumption.

Protocol Specification

Protocol Data Forms

Defines the three data forms: COMMAND, EVENT, and RESPONSE messages.

Basic Command Specification

Describes command structure, ASCII code usage, and parameter expression.

Command and Parameter List

Power, Input Source, and Volume Commands

Lists commands for power, input source selection, and master volume control.

Media Specific Commands

Details commands for M-DAX and favorite list management.

Analog Tuner Control

Analog Tuner Command Groups

Covers TF, TP, and TM commands for analog tuner frequency, presets, and band/mode.

DAB Tuner Command Groups

Covers TF and TM commands for DAB tuner station and band control.

Extended Network and Media Control

Extended Network Media Commands (NS)

Commands for extended control of network media, USB, and iPod Direct.

Event and Response Parameter List