Marantz SR7015 User Manual

Connecting a turntable
This unit is compatible with turntables equipped with a moving magnet (MM) phono cartridge. When you connect to a turntable with a low output moving
coil (MC) cartridge, use a commercially available MC head amp or a step-up transformer.
If you set this unit’s input source to “Phono” and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
NOTE
0
The earth terminal (SIGNAL GND) of this unit is not for safety grounding
purposes. If this terminal is connected when there is a lot of noise, the
noise can be reduced. Note that depending on the turntable, connecting
the ground line may have the reverse effect of increasing noise. In this
case, it is not necessary to connect the ground line.
GND
AUDIO
OUT
L
R
(MM cartridge)
Turntable
Contents
Connections Playback Settings Tips Appendix
85
Front panel Display Rear panel Remote Index

Marantz SR7015 Specifications

General

Channels	9.2
Power Output (6 ohm, 1 kHz, 0.7% 2ch Drive)	165W
Power Output (6 ohm, 1 kHz, 10% 1ch Drive)	235W
70% Guarantee	Yes
Audio Inputs	8
Multi-Channel Preamp Outputs	11.2
Subwoofer Out	2
HDMI Outputs	3
HDMI 2.1 Support	Yes
4K/120Hz Pass-Through	Yes
8K/60Hz Pass-Through	Yes
HDR Support	HDR10, HDR10+, Dolby Vision, HLG
eARC	Yes
Auto Speaker Calibration	Audyssey MultEQ XT32
Dolby Atmos	Yes
DTS:X	Yes
IMAX Enhanced	Yes
Auro-3D	Yes
HEOS Multi-room	Yes
Roon Tested	Yes
Wi-Fi	Yes
Bluetooth	Yes
Voice Control	Amazon Alexa, Google Assistant, Apple Siri
Ethernet	Yes
USB Port	1 (front)
Phono Input	Yes
Supported Audio Formats	MP3, WMA, AAC, FLAC, ALAC, WAV, DSD
Digital Inputs	2 Optical, 2 Coaxial
Zone Audio Output	2
HDMI Inputs	8 (1 front)
Speaker Terminals	11 (8 assignable)
Weight	14.8 kg