Daily alarm function
•
Press MODE/SET button to select to view: Time /
Time & Day of Week / Alarm Time ( “AL” shown on
the LCD)
•
When viewing the alarm time, hold the MODE
button for 3 seconds to enter the alarm setting
mode. Press + or - button to adjust alarm time.
Press the MODE button to confirm the setting.
•
Press AL ON/OFF button to activate or deactivate the
alarm function. If the alarm is activated, the icon
will appear on the screen.
•
Press the SNOOZE button to silence the alarm and
enter snooze mode, the alarm will sound again in 5
minutes.During snooze mode the icon will flash
on the LCD.
•
Press any button other than the SNOOZE button,
to stop the alarm. The alarm sound will continue
for 2 minutes before stopping.
NOTE: The snooze function can be repeated up to 7
times.
Dimmer
Press the
DIMMER button to adjust the LED brightness
(off-med-high), when powered by the adaptor,
Low battery indication
The low battery icon will display beside the
outdoor temperature digit indicating the outdoor
sensor battery is low and batteries should be replaced.
Precautions
•
Use a pin to press the reset button, if unit is not
working properly.
•
Avoid placing the clock near interference or metal
frames such as computer and TVs.
•
The clock will lose the time when the battery is
removed.
•
Do not expose to direct sunlight, heavy heat, cold,
high humidity or wet areas
Manual time setting
•
To enter the Clock/Calendar setting mode, press and
hold the MODE/SET button for 3 seconds until the
digits flash.
•
Press + or - button to adjust the desired value and
press the MODE button to confirm and move on to next
setting.
•
Hold down the + or - button to speed up setting
•
Press the MODE button to confirm settings and exit
from time setting mode. The time setting mode will
automatically exit after 15 seconds if no button is
pressed.
The setting sequence is shown as follow
1 Press = 12/24 Hour
2 Presses = Time Zone
3 Presses = Hour
4 Presses = Minute
5 Presses = Second
6 Presses = Language
7 Presses = Year
8 Presses = Month
9 Presses = Day
•
The days of the week can be displayed in 8 different
languages: German (GE), French (FR), Spanish (ES),
Italian (IT), Dutch (NE), Danish (DA), Russian (RU), and
English (EN).
•
The language and their select abbreviations for each
day of the week are shown in a table at the back of
this manual.
NOTE:
•
The Second setting is adjusted to zero only.
•
Time Zone function: If your area can receive an
RC-DCF frequency signal, the time zone function
should be set to 0. The Time Zone function is used
in areas where a DCF frequency signal can be
received but the time zone is different from the
German Time.
EN
To Next Page
Loading...
