Step 6
A typical session should last 30-60 minutes. If
being used for pain or recovery, sessions are
typically performed 1-2 times per day as needed
until recovered or pain free. For conditioning
and enhanced performance, the only difference
is consistency. Using the Marc Pro Plus
proactively (e.g., 1-2 times per day, 3 or more
days per week) creates the conditioning benefi ts
that will not only help muscles recover better, but
also help them perform better.
Note: In low frequency mode, longer sessions
(1-4 hours) can be used if needed to obtain
desired benefi ts. Fatigue should not be a
concern, but watch for skin irritation during
extended session times.
Step 7
When the session is over, turn the two intensity
knobs to the off position. Unplug the electrodes
and leads and place them back in their storage
container. It is important that the electrodes are
placed and sealed back in their Ziploc bag to
ensure that they last to their full potential (see
“Electrode Care” with any additional questions).
11
Additional Notes:
During your treatment you may use the built
in timer. Press down on the “Set” button until
your desired treatment time comes up on the
screen and then press “Start” to begin the
count down.
If at any time during your treatment you feel the
output interrupted and get a notifi cation saying
“Check Leads and Pads” followed by the
“Select Freq” notifi cation above the channel
display, this means the connection has been
compromised. Please turn knob to off position
on affected channel and check electrode and
lead wire connections; once corrected you may
reselect frequency and click on the knob and
turn back to desired intensity.
MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 11MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 11 9/1/20 5:43 AM9/1/20 5:43 AM
To Next Page
Loading...
