INSTRUCTIONS |
Step 1
Before the unit is used you must make sure that
the battery is charged. Take the unit out of the
case and hit the power button. The battery icon
on the screen should be partially or fully shaded
dark to indicate battery life. If the battery icon is
empty or fl ashing, then recharge the unit (see:
“Recharging the Battery”).
Step 2
Make sure all knobs are in the off position and
that the recharger is unplugged from the back of
the machine. Take the gray lead wires out and
plug the plastic end into the channel A output
jack. Take the black lead wires out and plug the
plastic end into the channel B output jack.
Step 3
Take out a package of electrodes and remove
from Ziploc bag. Next, connect the 4 pins on
the end of the lead wires to each of the four
electrodes. Place the electrodes on the skin
according to the diagrams on the following
pages. Note: Skin should be clean and dry.
Step 4
Get into a relaxed and still position (laying
down, sitting in a chair or on a couch). You
should be comfortable and the muscles being
worked should be free to contract without
resistance. If you are tense and resist the
contractions or if you’re in a position that causes
signifi cant resistance you will not benefi t from the
Marc Pro Plus.
Step 5
Once the pads are in place, hit the power
button at the top of the interface. Next, select
the frequency for each channel according to the
instructions on the following pages.
Click on the channel A and B intensity knobs
and slowly turn up each knob according to your
tolerance. The session protocols on the following
pages will give you an ideal setting range for
each channel.
-For low frequencies: You will start to feel a
gentle rhythmic pulsating sensation that will
get stronger and stronger as you turn the dial
up. A strong visible contraction is possible and
desirable in most areas of the body. An intensity
level between 6-9 is commonly reached, but it
is OK to turn the intensity up slowly. In general,
the higher the intensity, the better the results will
be. However...it is very important that the signal
level stay within your tolerance.
Remember: As long as the intensity is not raised
above your tolerance and you don’t resist the
contractions, even extremely strong and visible
contractions will not fatigue your muscles. This
is ideal for conditioning and is what makes the
Marc Pro Plus technology so unique.
-For high frequencies: You will start to feel a
gentle buzzing/vibration that will get stronger as
you turn up the dial. An intensity level between
4-9 is commonly reached, but it is OK to turn
the intensity up slowly. In general, the buzzing
sensation should be felt over your pain level and
typically the higher the intensity, the better the
results will be. However, it is very important that
the signal level stay within your tolerance.
10
MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 10MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 10 9/1/20 5:43 AM9/1/20 5:43 AM
To Next Page
Loading...
