CARE OF YOUR MARC
PRO PLUS |
Electrode Use & Care
• When electrodes (pads) are not in use,
always place on plastic sheet and seal in
Ziploc bag.
• We recommend that you change electrodes
after 20 uses. Conductivity will decrease due
to body oils accumulating on electrodes.
• Old or worn electrodes can also reduce
the comfort of stimulation.
• Only use the electrodes supplied by Marc Pro.
Other electrodes may present a risk of unsuitable
electrical characteristics with your stimulator.
• Do not use the same electrodes on several
different people.
PHYSICAL CHARACTERISTICS |
Length 7 inches | Width 4 inches | Height 2 inches | Weight 1lb 6oz
• Do not plunge the electrodes into water.
• Do not apply a solvent of any kind onto
the electrodes.
• Always stop the stimulator before remov-
ing or moving the electrodes.
• Always place electrodes on dry, clean, oil
and lotion free skin.
• If you’re using an optional aloe based
skin gel: use a small amount (about the
size of a pea) under each electrode. Rub
completely into the skin before placing
electrode. This can help ensure the most
comfortable and strongest signal.
Note: Electrode is 2 inch round with conductive hydrogel w/ .08” round female connector; not to exceed 0.1 Watt/cm2.
RECHARGING THE BATTERY |
• Before use, be sure that the battery is charged.
After powering on the device a battery indicator
on the LCD screen will give the current level. If the
battery icon is fully or partially shaded, then the
device can be used.
• If the battery icon is empty or flashing, the device
should be charged.
• To charge, plug the recharger into the back of the
unit and into the wall outlet. Charge for 8-12 hours,
or overnight.
• When done recharging always remember to
unplug the recharger from the back of the machine,
if it is left in, the unit will not work.
• A fully charged battery should last for 10 or more
hours of use.
MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 9MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 9 9/1/20 5:43 AM9/1/20 5:43 AM
To Next Page
Loading...
