Marc Pro PLUS+ - Page 11

9
A typical session should last 30-60 minutes. If being used for pain or recovery, sessions are typically performed 1-2 times per day
as needed until recovered or pain free. For conditioning and enhanced performance the only difference is consistency. Using the
Marc Pro Plus proactively (e.g., 1-2 times per day 3 or more days per week) creates the conditioning benets that will not only help
muscles recovery better, but also help them perform better.
Note: In Low Frequency mode longer sessions (1-4 hours) can be used if needed to obtain desired benets. Fatigue should not be
a concern, but watch for skin irritation during extended session times.
When the session is over, turn the two intensity knobs to the off position. Unplug the electrodes and leads and place them back in
their storage container. It is important that the electrodes are placed and sealed back in their Ziploc bag to ensure that they last to
their full potential. (See electrode care with any additional questions.)
Additional Notes:
During your treatment you may use the built in timer. Press down on the “select” button until your desired
treatment time comes up on the screen and then press “start” to begin the count down.
 Ifatanytimeduringyourtreatmentyoufeeltheoutputinterruptedandgetanoticationsaying“checkleadsandpads”
followedbythe“SelectFreq”noticationabovethechanneldisplay,thismeanstheconnectionhasbeencompromised.Please
turnknobto“offposition”onaffectedchannelandcheckelectrodeandleadwireconnections;oncecorrectedyoumayreselect
frequencyandclickontheknobandturnbacktodesiredintensity.
Step 7
Step 6